![]() ![]() However if the old unit used an external resistor coil, you must now run a wire from the ignition switch "on" position directly to the distributor to supply full 12 volts. Download Your Bruno Owners Manual (Note: Because all Bruno products are installed by authorized Bruno dealers only, Bruno Installation Manuals are not available. If the old unit had a coil with internal resistor and your new unit has the coil in the cap, no change needs to be made. We have 3 Bruno SRE-3000 Elan manuals available for free PDF download: Operators Manual, Basic Troubleshooting. The new unit needs full 12 volts to supply it so no resistor is used. Manuals and User Guides for Bruno SRE-3000 Elan. BRUNO VSL-6000 Curb Sider Vehicle Lift Powerchair Hoist. Make Offer - Bruno CRE-2110-W8 Stair Lift Chair Power Footrest Assembly New. The one other major issue is that a points style distributor has a supply wire with either a built in resistor, or a separate resistor inside the coil. SRE-2010 Electra-Ride Elite Stairway Elevator Technical Specifications INSTALLATION MANUAL & OPERATION MANUAL - CD - Bruno SRE-3000 Elan Stair Lift. Install new unit with vacuum advance similar to the old one and rotor at correct position, and as you lower unit into place insure that rotor points same as old one did before you started removing it. On new distributor, rmove cap and turn rotor to match the mark you made from old rotor position. Note position of vacuum advance and make a mark on engine where rotor is pointing as you remove dizzy. ![]() Remove holdown bolt, disconnect small wires and remove cap and slowly lift distributor up paying attention to how the rotor moves as you lift. Set engine on TDC with distributor rotor pointing at #1 plug wire. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |